FS: 2x CT15b Turbos - $200 Each!

[Tofu]

both in working cond (130,000~km)
good for someone who wants a spare to highflow!

1x available now
1x available end of february

ta,
Phil
021647974

[archon]

I might be keen for one as a spare

You Tomei'ing?

[Tofu]

Sure am mate!
I bought a spare turbo to highflow a while back however I bit the bullet and went with the M8280 instead so i'm now left with 2 spare ones once the Tomei goes on.

Where in NZ are you?

[archon]

Down in New Plymouth, you going to drop it off? Sweet!

Yeah the Tomei is hard to pass up, a brand new turbo, 100% bolt on and enough flow for 300rwkw (I have been knee deep in the threads on JZX100.com - as you probably have to), but I think a milder high flowed and steel wheeled ct15 might suit my needs better. Having said that I'll probably end up doing what you are... You doing the poncams too?

[Tofu]

I should beable to work something out for you. Flick me a PM.
The high flow will be a better turbo for the street as it'll keep its response on normal boost conditions (10-14psi) whereas the tomei doesn't give any major gain without more boost fed into it (16-23psi). I've just completed a big order from overseas and couldn't resist the turbo while I was at it.

I'm doing Pon Cams as well. Should be a healthy increase of power with them too based on Tomei's R&D
A really good read here: http://www.tomeiusa.com/recentmail.asp?mid=587

As the Steve Murch high flow is a similar size (based on Jared's measurements) it should give a very similar power figure in comparison to the Tomei minus the cost and bling factor.

[Tofu]

better late than never...
the other CT15B is available now if anyone needs one for a highflow or rebuild.

I've had no problems with it over the last 2 years. Still works fine.

Offers!