JZX NZ

Hi guys,

id like to run 2° Camber on the JZX and already have cucso Coilovers installed.
But unlike to my SX the cusco has no adjustable upper mounts.
same Problem in the rear.

How can i adjust the camber to my likings?
Are there any struts i can buy to modify the camber or what do i have to do?

THX for the help!

There is a bit of adjustment in the lower arms front and rear. The more you lower it, the more camber you'll get as well.

The inner lower control arm bolt on the front and outer lower control arm bolt on the rear are your camber adjustments.
Coilovers + factory adjustment should net you -2 degrees, although camber gain on the rear is a lot more when lowering the height so you may struggle to get it back to -2 with factory control arms.
Be aware that changing camber using LCA bolts will throw out the toe settings though, that doesn't happen with strut top adjustment but they only work for Mcpherson strut setups.

Well i got it sorted in the rear but i have prolems with the front.

I need to get the top of the wheel a little bit more under the Fender.
Are there no adjustable aftermarket upper wishbones for the JZX?

V12 wrote:Well i got it sorted in the rear but i have prolems with the front.

I need to get the top of the wheel a little bit more under the Fender.
Are there no adjustable aftermarket upper wishbones for the JZX?

Email nick at north shore toyota as cusco do a set for these and also he is one of the agents for them.

(Also one of our sponsors too i think)

Will be like these im sure....http://www.nengun.com/cusco/adjustable-front-upper-arms

What good for rear camber adjustable control arms? Cusco makes some I guess?