Page 1 of 1
Electronic Boost Controller install
Posted: Sun Apr 17, 2011 6:47 pm
by shweatypox
I grabbed me an EVC-III and want to know if someone has one, or similar, installed? Do I have to worry about a stock solenoid or can I just wire the thing straight up to the vvti 1j? Any help or photos
would be great
Re: Electronic Boost Controller install
Posted: Sun Apr 17, 2011 6:57 pm
by FLAWLES
i hooked up my evc-s and blitz sbc id -II up not worring about the vvti set up..just basicly a straight install
has this one got the big dual soleniod? or the single port one?
just have a high and low boost setting and you will be fine
it would be interesting to here what you have to say about the evc.. i personaly dont like it and want my sbc- II back
Re: Electronic Boost Controller install
Posted: Sun Apr 17, 2011 11:16 pm
by shweatypox
I wasn't sure which one to get but a couple of peeps mentioned the EVC III and up so I just got that one. I'll hopefully have it in this week so I'll let you know how it goes.
Re: Electronic Boost Controller install
Posted: Sun Apr 17, 2011 11:19 pm
by FLAWLES
fully
im by far no techno boffin and hat wires and anything push button, found the evc-s rather hard to sort out, but i beleve the evc-II is different and alot better than alot of the newer stuff coming out
dual soleniod is by far the best tho